54
For Support Visit· support.technocnc.com or Call: (631) 648-7481
HDS User Manual
(HTT06291133)
1 | Page
29 Trade Zone Drive, Ronkonkoma NY 11779
Office: (631) 648-7481
www.technocnc.com
Service and Maintenance
Caution
(1) Maintenance shall be performed by qualified personnel.
(2) Switch off the main power supply before servicing. If power supply is needed, have
qualified personnel operate it.
(3) Use genuine replacement parts and components.
Linear drive component Maintenance
Wipe the linear rails and bearings once a day to assure smooth play free motion.
Lubricate the rack and pinion and the ball screw drive once every week so as to ensure
longer service life.
When lubricating the z-axis screw, use a grease gun to inject grease into zerk fitting. It is
recommended to use Kluber TA 15/2 or PETAMOGY 193 or equivalent.
6.2
To Next Page
Loading...