Techno HDS Series - File System and Network Configuration; File Transfer and Management

26
For Support Visit· support.technocnc.com or Call: (631) 648-7481
HDS User Manual
(HTT06291133)
Section 2.3 File System | Network System
The PC is connected to the OSAI controller by an ethernet cable.
The Techno interface communicates in real time with the OSAI controller via the
ethernetcabletoallowjoggingandothermanualfunctions.
InordertorunG-codelestotheOSAIcontroller,theymustbecopiedontotheOSAI
controllers hard drive.
TheOSAIcontrollerisidentiedasanetworkdrivecalled
Y: OEM
and
X: USR
G-codelesmustbecopiedintotheProgramsfolderinorderfortheOSAIcontrollerto
locate and run them.
For convenience there is a shortcut to this folder on the desktop of the controlling PC.
This folder can be called “Programs” or “G-code Files.”
InordertorunaG-codele,itshouldrstbedraggedintothisfolder,andthen
accessed through the interface.
NOTE:TheOSAIcontrollerrunsinaLinuxtypeoperatingsystem,andsubsequently
lenamescanonlybe8characterslong,andtheyarecasesensitive.