Unit 11 / 18 Hinkler Court, Brendale Qld 4500 Ph 061 7 3205 9066
• Fit Foot Jack locate lock pin and level oven. Make sure water is level in each chamber with 10mm of wa-
ter in the oven floor. Note: the water level is very important as it effect the oven fat separation and
drainage. See below Levelling (if the floor is uneven we can use packers to level the oven)
• Complete check lists as attached. Turn oven on at mains
Touchscreen will illuminate after 10 seconds. Ensure the motor
turns in the correct direction. Single oven rotates clockwise.
• Check termination at oven power box for correct voltage on all
phases.
How to level the oven
• Levelling can be difficult depending on the fall of the floor, if the
floor is uneven we can use packers that are in the install kit.
• Firstly use the foot lock/level in position ensuring the Pin is in position
and bracket is hard against the leg.
• Once both locks are in place the oven can be checked for level,
with 10mm of water in both chambers water in the chamber
floor should be pretty even.
Double and Single Combined
The Double and Single oven combination share the one fat separator.
Plumping and wiring is connected.
Fat separato
To Next Page
Loading...
