Technogel Mixpasto 120

Questions and Answers

H
Heather LawrenceAug 7, 2025
What to do if the Technogel Commercial Food Equipment compressor starts and stops with error E06 + P MAX?
- G
  George OrtizAug 7, 2025
  If the Technogel Commercial Food Equipment compressor starts but stops almost immediately and the display shows “E06 + P MAX”, it's likely due to a pressure switch intervention caused by cooling water flow interruption. You should check if the water tap is open and ensure the water supply line is not obstructed. If the problem persists after these checks, you should seek Technical Assistance.
B
Bruce EspinozaAug 13, 2025
How to troubleshoot Technogel Commercial Food Equipment that does not switch on?
- W
  williamscharlesAug 13, 2025
  If your Technogel Commercial Food Equipment machine doesn't switch on, the possible causes are: 1. The power supply plug is not correctly inserted. 2. There is a faulty current socket or plug. 3. The fuse is interrupted. 4. The power supply cable is faulty. To resolve this: 1. Ensure the plug is properly inserted into the socket. 2. Check the current socket or plug. 3. Replace the broken fuse. 4. Replace the power supply cable.
M
Mark ReynoldsAug 17, 2025
What to do if Technogel Mixpasto 120 shows error E16 + TMAX F?
- C
  courtneyriosAug 17, 2025
  If the Technogel Commercial Food Equipment machine is running, but the mix isn't reaching the preservation temperature, the work cycle doesn't interrupt, and you see “E16 + TMAX F”, it could be due to: 1. A temperature probe not working. 2. A faulty control board. 3. A discharged refrigerator system. In this case, request Technical Assistance intervention.
R
Robert FarmerAug 22, 2025
Why is mix leaking from the tap of my Technogel Mixpasto 120?
- H
  hannahtranAug 23, 2025
  If you notice mix leaking from the tap on the external wall of your Technogel Commercial Food Equipment, it's likely due to missing, ruined, or badly assembled gaskets and O-Rings. You should check the assembly and replace the tap gaskets if necessary.
V
Virginia HoganAug 27, 2025
What to do if ice forms on the tank walls of Technogel Mixpasto 120?
- S
  sharon37Aug 27, 2025
  If ice or a thick mix crust forms on the tank walls of your Technogel Commercial Food Equipment, it could be due to: 1. A stirrer block or malfunction. 2. Mix quantity being below the prescribed minimum (20 l). To address this: 1. Check that the stirrer is properly inserted and that the control shaft regularly turns. If it doesn't, contact Technical Assistance. 2. Completely discharge the tank.
A
Andrea NelsonSep 1, 2025
Why is water leaking from the hose spray of my Technogel Mixpasto 120?
- M
  Michaela LeonardSep 1, 2025
  If water is leaking from the hose spray of your Technogel Commercial Food Equipment, it's likely due to a broken flexible hose or damaged gaskets. Replace the hose and/or tap of the hose spray.