EN13
Bind the device ->
Device binding successful ->
Confirm your location
Note: The weather station has dual power supplies. It uses 4 AA batteries and a USB
power supply. The WIFI function can work normally, but in order to ensure the
stability of the coupling connection, USB power supply is recommended
The base station will now start to make a connection to the outdoor remote sensor. This
operation takes about 3 minutes and is displayed by a flashing reception RF antenna
symbol “ ” in the “OUT”(outdoors) display area on the receiver. The “OUT” display
area will show an animation of the RF antenna symbol, indicating the base station is
searching for the signal from the outdoor sensor. At the same time the base station
began to establish WIFI connections (details see the WIFI connection description)
Receiving data
Receiving outdoor values
After inserting the batteries, the transmitter automatically starts transmitting the outdoor
values to the base station. The transmission is completed after approximately one
minute.
To Next Page
Loading...
