EN.4
ALARM SETTING
Press and hold ALM 1 button and at the same time press WAVE / HR button once at a time to set
hour or press MINUTE button once at a time to set minute.
Press and hold ALM 2 button and at the same time press WAVE / HR button once at a time to set
hour or press MINUTE button once at a time to set minute.
To turn on or off the alarm
To turn on Alarm 1 only, press ALM button. The ALM 1 LED lights up on the display.
To turn on Alarm 2 only, press ALM button again. The ALM 2 LED lights up on the display.
To turn on both alarms, press ALM button again. The ALM 1 and ALM 2 LEDs lights up on the
display.
To in-activate both alarms permanently, press ALM button again. The ALM 1 and ALM 2 LEDs
turn off.
Note: Alarm duration is 5 minutes.
To use the snooze function
When time reaches the set alarm time, the station will give a beep sound to wake you up. The ALM 1
or ALM 2 LED will flash.
1. Press SNOOZE once to stop the alarm temporarily, ALM 1or ALM 2 LED keeps flashing. The
alarm will beep again after the set snooze duration.
2. To stop the daily alarm, press ALM 1 or ALM 2 button when alarm is beeping. The alarm will
stop and ALM 1 or ALM 2 LED becomes static. The alarm will beep again same time next day.
To set snooze duration (from 5 to 60 min)
Press and hold SNOOZE and time display will show 05 (default snooze duration) and then press MIN
button to set your desired snooze duration.
DIMMER FUNCTION
Press the SNOOZE button to adjust high or low brightness of the LED display.
TROUBLE SHOOTING
In case the station shows false digits, it maybe affected by electrostatic discharge or interferences
from other devices. Press the RESET button of the station. The station will be reset to default
setting of time and calendar and it will start to receive radio controlled time signal again.
If you lose the outdoor temperature
When the outdoor temperature digits show “--“, the wireless transmission is either interrupted or lost.
Press the RESET button of the transmitter. If you continue to lose the outdoor temperature display,
try placing the transmitter in a different location until you have smooth transmission of temperature
data.
Note: Keep in mind that the outdoor transmitter only has a 30 meter transmission range in open area
with no obstructions. Each obstruction between the transmitter and the station (roof, walls, floors,
ceilings, thick trees, etc.) will effectively cut the transmission range in half.
Precautions
This main unit is intended to be used only indoors.
Do not subject the unit to excessive force or shock.
To Next Page
Loading...
Need help?
Operating Environment
