WS9050-DCF Manual
Setting the daily alarms:
Press “ ” button once, LCD will display “ ”, press again to display
“ ”, press again to display “ ”, each symbol represents one alarm, which
is active, when the bell symbol is displayed. Press “ ” button again to
Alarm1 and Alarm2 OFF (no“ ”and“ ”is displayed).
Press and hold “ALARM/SET” button for 2 seconds until Alarm 1 hour display
and starts to flash. Use the “UP” and “DOWN” buttons to set the hour.
Press “ALARM/SET” button to confirm your setting, The Alarm 1 minute
display and starts to flash. Use the “UP” and “DOWN” buttons to set the minute.
Press “ALARM/SET” button to confirm your setting, The Alarm 2 hour display
and starts to flash. Use the “UP” and “DOWN” buttons to set the hour.
Press “ALARM/SET” button to confirm your setting, The Alarm 2 minute
display and starts to flash. Use the “UP” and “DOWN” buttons to set the minute.
Press “ALARM/SET” button to confirm your setting and to end the setting
procedure.
Please note:
If there is no valid operation within 20 seconds, it will automatically return to
normal time mode from the set mode.
The alarm will sound for 2 minutes if you do not deactivate it by pressing any
button. In this case the alarm will be repeated automatically after 24 hours.
Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4
times whilst the alarm signal is heard.
Switching off the alarm signal
When the alarm is ringing, press any button except the “ ” button to
stop the alarm signal. It is not necessary to reactivate the alarm. It will ring again
the next day.
Snooze function:
When the alarm is ringing, press the “ ” button the alarm mode will to get
to SNOOZE mode. The alarm signal sounds again after approx. 5 minutes.
To Next Page
Loading...
