51
To wall mount
1. Secure the bracket onto a desired wall using the screws and plastic anchors.
2. Clip the remote temperature sensor onto the bracket.
Note:
Before permanently fixing the transmitter wall base, place all units in the desired
locations to check that the outdoor temperature reading is receivable. In event that
the signal is not received, relocate the transmitters or move them slightly as this
may help the signal reception.
CARE AND MAINTENANCE:
• Extreme temperatures, vibration and shock should be avoided as these may cause damage to the
unit and give inaccurate forecasts and readings.
• Precautions shall be taken when handling the batteries. Injuries, burns, or property damage may be
resulted if the batteries are in contact with conducting materials, heat, corrosive materials or
explosives. The batteries shall be taken out from the unit before the product is to be stored for a
long period of time.
• Immediately remove all low powered batteries to avoid leakage and damage. Replace only with
new batteries of the recommended type.
To Next Page
Loading...
Need help?
General
