GB 3
signal to correct any deviations to the exact time. If this synchronization attempt is unsuccessful
(the radio mast icon disappears from the display), the system will automatically attempt
synchronization at the next full hour. This procedure is repeated automatically up to total 5 times.
To start manual DCF-77 signal reception, press and hold down the “-” button for 3 seconds. If no
signals received within 7 minutes, then the DCF-77 signal search stops (the radio mast icon
disappears) and start again at the next full one hour.
Notes:
A flashing radio mast icon indicates that the DCF-77 signal reception has started
A continuously displayed radio mast icon indicates that the DCF-77 signal was received
successfully
We recommend a minimum distance of 2.5 meters to all sources of interference, such as
televisions or computer monitors
Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such
extreme circumstances, place the system close to the window.
During the time signal reception mode, press the “SNOOZE/LIGHT” button to stop time signal
reception mode
Manual time setting:
Press the “TIME SET” button to enter time setting mode and “dcf ON” blinks on the display.
Press the “ + ” or “ - “ button to set DCF reception off with OFF or set DCF on with ON.
Press the “TIME SET” button to confirm your setting and “TZ 0” blinks on the display. Press the
“ + ” or “ - “ button to set a time zone difference from -11 to +12. For example, set 0 for
Germany or -1 for the UK.
To Next Page
Loading...
