TS-7400/TS-9441 MANUAL
INTRODUCTION
✔ USB-FLASH-256: 256 MB flash drive with full ARM tool chain installed and Debian
✔ WIFI-G-USB: Linux-supported USB 802.11g WiFi transceiver for wireless networking
✔ TS-9441 : Boot/Console Peripheral Board for TS-7400 (required during development)
(included in the KIT-7400)
✔ TS-DC420-ENC: Peripheral board provides 8-30VDC power input, Xbee radio socket,
DIO lines, 3 A/D channels, 3 COM ports, RS-485/RS-422 with full-duplex and
aluminum enclosure
✔ PS-18VDC-REG: Regulated 18VDC wall mounted power supply (compatible with OP-
PS30V)
✔ PS-5VDC-1AMP: 5VDC 1AMP Power Supply (100-120V) (included in the KIT-7400)
✔ PS-5VDC-2_5REG: 5VDC 2.5AMP Regulated Power Supply
Note
Check our website at www.embeddedARM.com for an updated list of options
and external accessories
© May, 2010 www.embeddedARM.com 7
To Next Page
Loading...