Technomate TM-5500 Series - Page 2

TM-5500/5000 Quick Setup Installation Guide
Instruction Manual for Technomate TM-5500/TM-5000 series
All Technomate receivers are fully tuned with 23 satellites and more than
3500 channels.
How to View Pre-tuned Receivers- Fixed System (non-motorised)
After connecting the receiver to the TV, turn ON the receiver. Press the
atellite button on the remote. Select a Satellite of your choice and press OK
n the remote. On the left-hand of the screen, select the Channel with the D
K to view.
Fixed System for One LNB or one Dish
s
o
sign (not the $D sign) using the up and down arrows on the remote. Press
O
How to Tune a
mote until you see Installation. Press OK. Use the left/right arrows to
s, select Satellite
ist. Press OK on your selected satellite and OK again. When the signal
s
ress the Channel up/down buttons to view a picture by selecting D (Free-
ow to Setup a Monoblock or DiSEqC Switch (up to 4 LNBs/Dishes)
Press the Menu button on the remote. Use the left/right arrows on the
re
select Satellite List.
A pop-up menu will appear. Use the up/down arrows on the remote and
select a satellite of your choice. Press the red button on the remote to Save
and Exit.
Go to Auto-Search and press OK. Using the left/right arrow
L
quality is at the highest strength, press OK to tune. Wait until the word
“Tuning Finished” appears and press Exit until a clear screen appears.
P
to-air) not $D (Scrambled) channels, to view $D channels you need a cam
(decoder) and a viewing card.
H
to
e
mote to select a satellite, for example Hotbird 13 degrees East. Go to
Press the Menu button the remote. Use the left/right arrows on the remote
find Satellite Setup and press OK. Use the left/right arrows to select
Satellite List. A popup menu will appear. Use the up/down arrows on th
re
2