3. Adjust the function adjustment wheel (2) to function 1.2 or 3, shown in Fig.
4.Move presser bar lifter(20) upward, lift presser foot (17) and pull the bobbin
thread and upper thread backward for about 10cm, shown in Fig4.
5. Put texture under the presser foot (17) and move presser bar lifter(20)
downward to hold the texture, shown in Fig5.
6.Turn power switch (25) “ON” and stamp foot switch (31) gently to start sewing,
shown in Fig6.
7.Guide texture gently during sewing, shown in Fig7.
8. Rotate counter clockwise the hand wheel (24) after finishing sewing to lift the
sewing needle
(16) to the highest position, shown in Fig8.
9. Move presser bar lifter(20) upward and lift presser foot (17), shown in Fig9.
10. Move out the texture and cut thread with thread cutter (10), shown in Fig10.
“Zigzag” sewing
Sewing method of “Zigzag” sewing is same as that of straight sewing except for
adjusting the function adjustment wheel (2) to function 4, 5, 6 and 7.
13
To Next Page
Loading...
Need help?
General
