Need help?Do you have a question about the Teckentrup CarTeck and is the answer not in the manual?
Specifies the intended use for the garage door system, including usage limits.
Defines who is authorized for assembly, operation, and maintenance, including required qualifications.
Provides crucial general safety advice and instructions for safe installation and operation.
Details how solar radiation can affect dark-coloured doors and potential remedies.
Lists the components included in the door package: door leaf, frame, and accessories.
Lists and describes various types of screws used in the assembly process.
Specifies prerequisites for the installation site, including floor completion and wall plastering.
Lists tools not included in the scope of delivery, necessary for the assembly process.
Details how to measure the door opening dimensions and check for suitability.
Explains how to establish a correct reference level for frame installation.
Provides instructions for installing the lintel casing, including two variants.
Describes how to set up the frame for installation, either in front of or in the reveal.
Details the process of aligning and fixing the frame correctly in the door opening.
Explains two variants for fastening the frame when installed in front of the reveal.
Details the steps for fastening the frame when installed inside the reveal.
Details the steps for fastening the frame when installed outside the reveal.
Provides instructions for installing the lintel casing, including two variants.
Details fastening the lintel casing directly through it into the masonry.
Details the process of assembling the guide rails onto the door frame.
Shows how to prepare and install the upper guide rails on the frame.
Explains how to fasten the upper guide rails correctly to the frame brackets.
Details how to fasten the upper cross strut to the drive rail and spring channel.
Provides instructions for installing the spring package components into the rail system.
Details the steps for assembling and routing the wire rope correctly.
Explains how to fit and secure the spring channel cover.
Instructions for assembling the spring channel cover for double and triple spring systems.
Instructions for assembling the spring channel cover for quadruple spring systems.
Details the process of assembling and aligning guide rails on the ceiling.
Details how to fasten and align the upper guide rails on the ceiling.
Provides instructions for assembling and aligning the lower curved guide rails.
Explains how to attach and secure the suspensions onto the guide rails.
Covers the process of assembling the individual door sections.
Covers preparing the lower door section, including end profiles and protective film.
Provides instructions for assembling subsequent door sections.
Details the assembly process for the top section of the door.
Details the steps for attaching the wire rope to the door leaf.
Explains how to adjust the spring tension for proper door operation.
Provides warnings and safety guidelines for operating the garage door.
Details the procedure for operating doors manually, including opening and closing.
Provides safety advice for operating doors with a drive system.
Safety checks required before commissioning the door system.
Checks for proper door movement, alignment, and end position engagement.
Instructions for removing protective film from the door sections.
Details routine maintenance tasks to be performed by the door owner.
Specifies maintenance tasks for qualified personnel according to EN 12635.
Safety warnings and instructions for disassembling the door system.
Guidelines for proper disposal of the door system and drive components.
Information on wear parts and conditions for warranty recognition.
General| Manufacturer | Teckentrup |
|---|---|
| Type | Garage Door Opener |
| Operating Temperature | -20°C to +60°C |
| Power Supply | 230V AC, 50Hz |
| Maximum Door Width | 6m |
| Control | Remote control, push button |
| Safety Features | Obstacle detection |
| Protection Class | IP44 |
To Next Page
