10
Warning
1. The appliance has to be unplugged after use and before carrying out user maintenance on
the appliance.
2. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
3. Children should be supervised to ensure that they do not play with the appliance.
4. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
5. Please abandon the refrigerator according to local regulators for it use flammable blowing
gas and refrigerant.
If the above methods are not yet effective, please contact with the maintenance service
department for help without any delay.
6. Cleaning and maintenance
Before you start to clean your freezer remove the mains plug from the power supply.
Use a clean sponge or soft and a mild detergent in warm water. Do not use abrasive or harsh
cleaners.
Hand wash, rinse and dry all surfaces thoroughly.
Do not use cleaning waxes, concentrated detergents, bleaches or cleaners containing
petroleum on plastics and rubber parts.
Never use paper towels, window sprays, scouring cleansers or flammable fluids on plastic
parts as these can scratch or damage material.
Clean with a cloth soaked in this solution and then dry with a soft cloth.
It is recommended to clean the unit each time it is defrosted to help keep the unit odor free
and running efficiently.
Vacation Time
Unplug the freezer.
Defrost and clean the freezer.
Leave the door open slightly to avoid possible formation of condensation, mold, or odors.
Use extreme caution in the case of children. The unit should not be accessible to child’s
play.
7. Troubleshooting guide
You can solve many common freezer problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
Temperature control is set too warm. Turn the control to a
cooler setting and allow several hours for the temperature
to stabilize.
Door is kept open too long or is opened too frequently.-
Open the door less often.
The door is not closed completely.
The door gasket does not seal properly.
A large amount of warm or hot food might have been stored
To Next Page
Loading...