Page 7 / 15
Basic technical data:
Depth of parameters tested
- 50m
Maximum supply pressure
- 300 bar (232 bar INT (Yoke) connections)
Reduced pressure
- 9.0 – 10 bar
Threads:
Valve connection:
- DIN 5/8”
- INT (Yoke)
High pressure plug
- 7/16” (number depends on a model)
Medium pressure plug
- 3/8” (number depends on a model)
4. Intended use
Demand regulators presented in this manual are diving gas regulators used for
recreational and professional diving. Demand regulators are used with a single diving
cylinder or twinset of operating pressure up to 30 MPa (300 bar).
CAUTION
Scubatech / Tecline shall not assume responsibility for malfunctioning of
demand regulators if they have been used contrary to their purpose, if
unoriginal spare parts have been used or if they have been serviced by a
person not authorised by Scubatech / Tecline.
5. Using with nitrox
IMPORTANT
Important information regarding the use of demand regulators with nitrox
mixtures is described below.
CAUTION
Diving with the use of nitrox mixtures requires completion of a specialist
training. Diving with the use of nitrox mixtures without specific knowledge and
skills may lead to serious health problems or death.
CAUTION
Diving with the use of nitrox mixtures requires application of specific
equipment and procedures that differ from those required by a user of
standard compressed air.
Using demand regulators with nitrox mixtures outside the EU (European
Union).
Standard Scubatech / Tecline demand regulators sold to non-member EU countries
are produced with the application of materials, assembly procedures and greases
that ensure compatibility with nitrox mixtures of the maximum oxygen content of 40
%.
To Next Page
Loading...