To Next PageTo Next Page
Need help?Do you have a question about the TecLINE TDE 183 and is the answer not in the manual?
General| Brand | TecLINE |
|---|---|
| Model | TDE 183 |
| Category | Water Heater |
| Language | English |
Covers electrical hazards, liability, qualified personnel, and proper installation procedures.
Unpack the device and remove the cover. Check for transport damage.
Use the supplied mounting kit and prepare water and electrical connections.
Securely mount the instantaneous water heater to the wall, considering wall unevenness.
Connect the water supply and flush the device for one minute to vent.
Connect the electrical supply, ensuring proper cable length and connection.
Switch on the fuses, set the temperature, and perform a start flush.
Adjust water temperature continuously using the electronic control.
Open hot water tap fully; close slightly if temperature is too low due to high flow.
Adjust the temperature dial to a lower setting.
Set desired temperature directly on the device; avoid mixing cold water.
Wipe the device with a damp cloth; avoid abrasive cleaners.
Check and clean sieve in faucet or showerhead; check heating element sieve.
Reduce flow, check heating element sieve, or adjust temperature setting.
Check safety devices, check flow rate, or check inlet water temperature.
Air detection system may briefly interrupt heating; check flow rate.
Contact customer service with E-Nr. and FD-Nr. for assistance.
Dispose of the device according to WEEE directive and local regulations.
Details warranty terms, conditions, and exclusions for Germany and Austria.
Confirms compliance with EU directives for low voltage and electromagnetic compatibility.
