BREATHING TUBE
WARNING
Always inspect the PAPR end of the breathing tube to confirm the rubber O-ring is in place, see fig.7a.
Replace if missing or damaged.
Be sure tube is properly installed and non-filtered air cannot enter the facial.
Assembling
Insert the two prongs on the breathing tube into blower unit and headtop receptacle (See
fig.6), twist 1/4 turn to the anti -“OPEN” direction to lock into place (See fig.7a).
Disassembling
Twist 1/4 to the “OPEN” direction and then take the prongs out from the end (See fig.7b) .
fig.6
Breathing tube
O-ring
fig.7a
Assembling from blower
fig.7b
Disassembling from blower
7
Do not put PAPR unit with power-on in the package. It’s better to remove the battery
from the body when put in the package.
Do not keep PAPR unit inside the car in hot summer season.
Do not throw or give the high impact to PAPR unit.
Do not put PAPR unit on the electric heat generating equipment.
Do not use any other battery charger.
Battery storage temperature: 14°F to 115°F (-10°C to 45°C), R.H.< 85%.
Notice of battery use
•
•
•
•
•
•
•
•
To Next Page
Loading...