PROVASET 2P code 2P2B00 - 2P6B00 - Instruction manual
rev. 14/02/2013
page 5
INDEX OF CONTENTS
1 INTRODUCTION
2 DESCRIPTION AND INSTALLATION
2.1 Front panel
2.2 Rear panel
3 PNEUMATIC DIAGRAM
4 TESTING CYCLE
4.1 Leak test cycle with three-phases
4.1.1 Operating principle
4.1.2 Testing cycle procedure
4.1.3 Three-phases testing cycle (T1, T2, T3)
4.2 Leak test cycle with two-phases
4.2.1 Operating principle
4.2.2 Two-phases testing cycle (T1, T2)
4.3 Errors relating to the testing cycle
4.4 Test results
4.5 Alarm indications: Causes and solutions
4.6 Obstruction test
5 MESSAGE DISPLAY
5.1 Base menu structure
5.2 Message displayed at power on
5.3 LCD contrast
5.4 Message menu
5.5 "TEST COUNTERS" menu
5.6 Instantaneous reading of the pressure sensor
6 PROGRAMMING
6.1 Using the keyboard
6.2 "TEST TABLE selection" select menu
6.3 "TEST TABLES" modify menu
6.4 "CONFIGURATION AND OPTIONS" menu
7 CONNECTION TO PROGRAMMABLE LOGIC CONTROLLER /PLC
7.1 Interface with the PLC: Features, signals and connection
8 CALIBRATING THE PRESSURE SENSOR
8.1 Calibration method
8.2 "PRESSURE CALIBRATION" menu
9 TECHNICAL FEATURES
DECLARATION OF CONFORMITY
GUARANTEE
TECHNICAL SERVICE REQUEST
USER INFORMATION EUROPEAN DIRECTIVE 2002/96/EC
To Next Page
Loading...
