Need help?Do you have a question about the TECNA PROVASET 2P and is the answer not in the manual?
Details the controls, display, and air outlet connection on the front panel.
Describes the pressure reducer, PLC/foot switch connector, and power switch/socket.
Details the air inlet connector and explains the equipment label information.
Illustrates and explains the device's pneumatic circuit, including key components.
Explains the operating principle, parameters, and procedures for three-phase leak tests.
Explains the operating principle and procedures for two-phase leak tests.
Covers test results, alarms, errors, and interpretation of test outcomes.
Explains how to enable and perform an obstruction test to check for blockages.
Details the base menu structure and navigation using keys.
Explains power-on messages, LCD contrast, and test counter menu.
Explains how to view the real-time pressure sensor reading via the Message Menu.
Describes the function of each key for menu navigation and operation.
Covers selecting and modifying test tables and their parameters.
Details settings for language, units, test phases, start commands, buzzer, and obstruction tests.
Details the PLC connector, pinout, and input/output signals for communication.
Illustrates PLC signal timing and describes connections for external start and LEDs.
Outlines the procedure and requirements for calibrating the pressure sensor.
Guides through accessing and performing zero and gain calibrations via the menu.
Lists key technical specifications including power, air, fuses, operating conditions, and resolution.
States compliance with Low Voltage Directive and EMC Directive, and relevant standards.
Details the product guarantee period, exclusions, and service conditions.
Provides information on the disposal of the product at the end of its life cycle.
Contains fields for customer and equipment details for service requests.
General| Brand | TECNA |
|---|---|
| Model | PROVASET 2P |
| Category | Test Equipment |
| Language | English |
To Next Page
