Section 4 – Normal procedures
NORMAL PROCEDURES CHECKLIST
3.3. COCKPIT INSPECTIONS
Instruct passengers on how to use safety belts and normal / emergency
exits. Passenger embarkation should be done, avoiding contact with hot /
oily parts such as engine exhaust pipes, drainage tubes and wheel brakes,
or sharp wing control surfaces edges.
Do not smoke on board
CHECK if within the limits
Remove seat belt used as lock
Landing gear control knob
ON, check fuel pressure gauge correct
operation and advisory light turned ON.
OFF, check pressure decreased at zero
ON, check fuel pressure gauge correct
operation and advisory light turned ON.
OFF, check pressure decreased at zero
Electrical pitch trim selector (if in-
stalled)
Operate control to FULL position.
Verify extension. Retract flaps.
Rudder trim control
Eng.Starting Battery Voltmeter (optional)
Set to neutral position.
Check 12 to 14 Volt