Page 6 of 14
EN
Refrigerator Diagram-- Preparation
p
This diagram may vary slightly wit h the layout of the refrigerator you have
just urchased due to technical im provements.
Preparation
Unpacking
Remove
all
packing
materials.
Check
attachments
and
materials
Checking
should
be
conducted with reference to the Packing List. Contact the local
distributor
if
discrepancies
are found.
Ensure
proper
location
of
the
refrigerator.
*Make sure the refrigerator is kept upright during handling.If an inclination is required,
it should not exceed 45 degrees. Otherwise the appliance may get damagedresulting
not only in compromised refrigeration performance.
*To avoid product damage or personal injury, the refrigerator should be unpacked
by two persons after it is located in a previously selected position.
*Before installation,make sure the refrigerator has no visible exterior damage.
*When handling the refrigerator, do not lift it by holding the worktop, to prevent
any damage to the refrigerator.
*Do not start up a refrigerator that is damaged.
Clean the refrigerator before use.
(See the following section “Cleaning”)
Idle time
After the refrigerator has been sited and cleaned, let it stand for more than 30 minutes
before connecting the power source.
Version E1.0 of EN 03/2016
Page 9 of 14
Instructions
* Do not store excess quantities or weights of food; food should be stored with spaces in
between for better storage results. Never overload shelves, as they may collapse under
excessive
loads.
* Food to be stored should be sorted according to consumer requirements. Food consumed
daily should be placed in the most convenient area, this will minimize opening periods for
the door. Do not place food too close to the internal walls.
Food holder cleaning
*
Food holders can be taken out for cleaning
Lamp:
*Lamp: 220-240V,15W
Version E1.0 of EN 03/2016
EN
If the interior light in the refrigerator section is not working.
*
Disconnect the appliance from the mains.Switch off at the wall and withdraw the plug from
the socket,or disconnect the mains fuse or remove the screw-out fuse in countries where
this is appliance.
Grasp the lamp cover at the top and at the bottom(1),and pull it forwards to remove(2).
Unscrew the lamp.
Change the lamp.
Screw the new lamp into the connection.Make sure the safety catch is correctly fitted.
Replace the lamp cover,and click it into place at the sides.
4
3
5
4
3
5
1
1
2
Lamp
1.Shelves
2.Vegetable and fruit tray
3.Temperature Controller
4.Egg tray
5.Bottle racks
1
2
3
4
5
6
7
6.Adjustable screw(left)
7.Adjustable (right)screw
To Next Page
Loading...