10
NOTE :
Before washing, please make sure the washing machine is installed properly.
Your appliance is thoroughly checked before it leaves the factory. To remove any residual
water and to neutralize potential odors, it is recommended to clean your appliance before first
use. For this reason, start the Cotton program at 90°C without laundry and detergent.
Sort the laundry and put it into the drum.
Do not get laundry caught in the door. It can cause damage to the door seal.
Do not put too much laundry into the drum. It can cause excessive vibration or
damage to the appliance.
Add the detergent according to the amount of laundry, degree of soiling,
water hardness and manufacturer’s instructions.
Pour liquid detergent into the appropriate dispenser drawer and push in the
appliance.
Calibration :
It’s recommended to calibrate the washing machine, so that provide the best performance.
The appliance is able to detect the amount of laundry loaded. This function is optimizing the
product performance by minimizing energy and water consumption, saving you money and
time. For this reason it’s recommended to calibrate the appliance for best use.
1. Remove all accessories from the drum and close the door.
2. Plug in the appliance.
3. Switch on the washing machine and press and
simultaneously for 10 seconds until “t19” is displayed.
4. Press to start the appliance and wait till “****” is displayed.
To Next Page
Loading...