TECNORD
RC-DBX/PCM/NBM Use and Maintenance Manual Page 5/23
2 RC-DBX, RC-PCM SYSTEM’S COMPONENTS
A Tecnord’s RC-DBX Remote Control System includes the following parts:
¾ For RC-DBX Systems: SHW TRANSMITTER UNIT (Single Hand Wander, SHW-TX)
¾ For RC-PCM Systems: PCJ TRANSMITTER UNIT (Shoulder Strap Transmitter, PCJ-TX)
¾ DBX RECEIVER UNIT (DBX-RX) and Flying Connectors
¾ BATTERY CHARGE CABLE with plug-in for in vehicle cigarettes-lighter
¾ BATTERIES (included in the Transmitter Unit)
The following parts can be provided as an option:
¾ SERIAL CABLE (serial/battery charger cable)
¾ CUSTOMIZED HARNESS
¾ TRANSMITTER FIXING MAGNET
¾ PROGRAMMING UNIT WITH DISPLAY
All the above mentioned parts are also available as spare parts.
2.1
Transmitter Unit Control Configurations
RC-DBX transmitters (SHW-TX) can be provided in several control configurations, dependign on customer’s requirements.
Basically, control configurations differ in the number and type of actuators. The figures below show the available actuators, while the
next table outlines the actuators available in the various control configurations.
CONTROL
CONFIGURATION
On-Off switches Start/Stop switch Proportional trigger PRS Emergency-Stop
RC-DBD 4 / 5 / 6 Yes No - Yes
RC-DBR 4 / 5 / 6 Yes Yes - Yes
RC-DBM - Yes No 4 / 5 / 6 Yes
RC-PCM transmitters (PCJ-TX) are designed for systems with multiple proportional actuators. The control configuration
therefore varies with the number of joysticks provided. Standard equipped actuators are shown in the figure below.
CONTROL
CONFIGURATION
JLP Joysticks Optional Functions Speed Selection Pushbutton Emergency-Stop
RC-PCM 4 / 5 / 6 / 7 Yes Yes Yes Yes
Proportional
Trigger
On-Off
Toggle switches
Start/Stop
Toggle switch
Connector for
battery charging and
cable communication
PRS (Proportional
Rocker Switches)
Emergency-Stop
Pushbutton
Pushbutton for
radio engagement and
auxiliary output
Toggle switches for speed selection
and auxiliar
To Next Page
