Install/Disable/Delete users
Install users (function #1)
Hold press util the double beep. Led remains on.
Enter the Manager code (and the Dallas key if programmed). The keypad
beeps twice.
Enter the number of the user to be installed. The keypad beeps twice.
Enter the code (and the Dallas key if needed) of the new user. The
keypad beeps twice.
Confirm the code (and the Dallas key if programmed) of the new user.
The keypad beeps twice and the led switches off.
Note: it’s only possible to install the override user during the open window counting.
Disable/Enable users (function #2)
Hold press util the double beep. Led remains on.
Enter the Manager code (and the Dallas key if programmed). The keypad
beeps twice. All the users (but Manager) are disabled/enabled.
Delete users (function #3)
Hold press util the double beep. Led remains on.
Enter the Manager code (and the Dallas key if programmed). The keypad
beeps twice.
Enter the number of the user to be deleted. The keypad beeps twice and
led switches off.
This function allows for verification that the system is operating correctly.
Hold press util the double beep. Led remains on.
Enter the following sequence of keys:
Any working button produces 2 short beeps.
A damaged button produces a long beep and the keypad switches off.
To Next Page
Loading...