TECO 28 Special - Recommended Fire-Extinguishing Devices

User’s manual - TECO 28 special 25
Precautions for the use of oil
- Avoid contact with the skin.
- Do not allow oil mists to form or spread in the atmosphere.
- Observe the following elementary health precautions:
• protect against oil splashes (appropriate clothing, protective guards on machines);
• wash frequently with soap and water; do not use cleaners or solvents that can irritate your skin
or remove its natural protective oil;
• do not dry hands with dirty or greasy rags;
• change clothing if impregnated with oil, and in any case at the end of every working shift;
• do not smoke or eat with greasy hands.
- Also adopt the following preventive and protective equipment:
• gloves resistant to mineral oils, with lining;
• goggles, in case of splashes;
• aprons resistant to mineral oils;
• screens to protect against oil splashes.
Mineral oil: first aid procedures
- Swallowing: seek medical attention, providing the characteristics of the type of oil swallowed.
- Inhalation: in case of exposure to high concentrations of fumes or mists, take the affected person
to the open air and seek medical attention immediately.
- Eyes: rinse with plenty of running water and seek medical attention as soon as possible.
- Skin: wash with soap and water.
RECOMMENDED FIRE-EXTINGUISHING DEVICES
For guidance on the most suitable type of extinguisher, refer to the table below:
Dry mate-
rials
Flamma-
ble
liquids
Electrical
equip-
ment
Water YES NO NO
Foam YES YES NO
Powder YES* YES YES
CO
2
YES* YES YES
YES* Use only if more appropriate extinguishers are not at hand or when the re is small.
WARNING
This table contains general instructions intended to be used as guidelines for users. Contact
the manufacturer for details of the applications of each type of extinguisher.
GLOSSARY
Air delivery regulator: Union allowing regulation of the air ow.
Beading: Operation which takes place during ination and ensures perfect centring between the
bead and the rim edge.
Bead breaking: Operation in which the bead of the tyre is detached from the edge of the rim.
Bead pressing gripper: A tool intended for use when mounting the top bead. It is tted so that it
grips the shoulder of the rim and holds the tyre top bead inside the drop centre. It is generally used
for mounting low prole tyres.
Tubeless Inator: An ination system which simplies inating tubeless tyres.
Bead: The edge of the tyre that remains in contact with the rim when the tyre is installed.
Tubeless: A tyre without an inner tube..