16
TANK
CHILLER LINE
EN
• press button a second time. The display will start to fl ash the value of the hour set. Set the value using
buttons
and .
• press button a third time. The display will start to fl ash the value of the minutes set. Set the value using
buttons
and .
• When the procedure is complete, the button LED should light up.
• To cancel the setting, press
and subsequently button . The button LED should go out.
To set the SWITCH OFF timer:
• Press button . The display will start to fl ash the set time
• press button a second time. The display will start to fl ash the value of the hour set. Set the value using
buttons
and .
• press button
a third time. The display will start to fl ash the value of the minutes set. Set the value using
buttons
and .
• When the procedure is complete, the button LED should light up.
• To cancel the setting, press button and subsequently button . The button LED should go out.
5.3.6 OTHER PARAMETERS
Press the button to check the internal parameters of the thermometer for diagnostic reasons (the parameters
may only be checked and not changed).
5.4 USING THE DISPLAY REMOTELY
It is possible to move the thermometer display from the conditioner and place it in another environment. The
maximum distance between the conditioner and the display is governed by the length of the cable contained in
the package (10m)
Follow the instructions below to use the display remotely:
1) Disconnect the power to the machine
2) Open the display protection guard
3) Dismantle the display by levering the lower part
4) Disconnect the connector from the display
5) Use the extension by attaching the respective connectors
6) Mount the second protection guard at the position in which the display will be fi xed and lastly, install the
display.
5.5 TRANSPORTATION AND STORAGE
The conditioner must be transported, and kept, in the vertical position.
The conditioner must be transported, and kept, on top of a pallet with suitable packaging to ensure its stability.
If the machine should fall or be placed in a horizontal position, once correctly installed, wait at least 24 hours
before turning it on.
5.6 DEMOLITION AND DISPOSAL
The crossed-out wheelie bin label that can be found on your products, indicates that the product may
not be treated as household waste. By ensuring that this product is disposed of correctly, you will
help preventing potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of these products. For more detailed
information about recycling of this product, please contact your local city offi ce, your household
waste disposal or the dealer where you purchased this product.
This information only applies to customers in the European Union, according to Directive 2002/96/EC of EU-
ROPEAN PARLIAMENT and THE COUNCIL OF 27January 2003 on waste electrical and electronic equipment
(WEEE) and legislation transposing and implementing it info the various notional legal systems. For other coun-
tries, please contact your local government to investigate the possibility of recycling your product.
To Next Page
Loading...
