Teco Australia Pty Ltd will not warrant the equipment supplied, if the comply
with
the Building Code of Australia or any Local Government standard or code. The customer/contractor is solely
responsible for ensuring that the equipment installed complies with all relevant building codes or standards.
Due to various wall and window types and construc ons, Teco Australia Pty Ltd recommends the window/wall
type room air condi oner must be installed with compliance to the Building Code of Australia, Local Government
or body corporate requirements. Please consult your local builder or air condi
oning contractor.
All hardware required to install the air condi oner is eld supplied.
performance.
1.
2.
The Cooling model has only one drain hole with rubber plug fied.
to the drain hole if the noise of splashing water bothers you or if
the water droplets splashed through the condenser coil drops to the ground below causes a trip hazard
or during Winter to release defrosted water quickly from the base.
To install a drain line please follow the steps below:
1. Slide out the chassis from the cabinet.
2. Remove the rubber plug from the body base plate.
3. Install the drain pan to the corner of the cabinet with 2 screws.
4. Slide the chassis into its original place in the cabinet.
5.
WARNING:
water thermostat mounted above.
Drain Holes
Drain Plug
The cooling and heating model has two drain holes:
(For illustration
purposes only)
To Next Page
Loading...
