40
Adjust the stop bracket to prevent the control lever
from moving any further counterclockwise. Then tighten
the stop bracket screw.
Loosen the actuating cam lock screw enough to allow
adjustment of the cam. Position the cam so that it
opens the throttle completely, making sure that the
cam doesnt cause binding on the post.
When the correct position is attained, tighten the lock
screw on the high end to hold the cam in place.
Move the control lever to align the RUN trigger of
the ignition unit with the number 2 position of the timing
tool. Hold this position.
Adjust the actuating cam to touch the post without
moving it. Tighten the lock screw to hold the cam in
place.
Recheck to insure that the high speed point hasnt
changed or that binding will not occur. Readjust from
the high speed point to the pickup point as necessary.
When assured that the cam position is correct at the
FULL RUN and IDLE positions, torque the lock screw
to 10-15 in. lbs.
"START"
TRIGGER
POS. -2
"RUN" TRIGGER
TOOL 670238A
THIS SIDE UP
2
LOCK SCREWS
THROTTLE POST
CONTROL LEVER
STOP BRACKET
GREASE CAM
SURFACE
THROTTLE
ACTUATING
CAM
SCREW
LOCKING
SCREWS
THROTTLE POST
CONTROL LEVER
STOP
BRACKET
THROTTLE
ACTUATING
CAM
"RUN"
GROUND SCREW
To Next Page
Loading...
