181-1273-14 Four-Cycle Twin Cylinder Engine • Vertical Crankshaft • Air-Cooled Page 5
B. Filling Oil Sump
1. Be sure engine is upright and level.
2. Unscrew oil fill cap/dipstick from oil filler tube and wipe
dipstick clean. See Figure 7.
3. Screw oil fill cap/dipstick back into oil filler tube. Tighten
securely.
4. Unscrew and remove oil fill cap/dipstick from oil filler
tube. Note oil level. If oil reading on dipstick is below
“ADD” mark, slowly add oil to reach “FULL” level. See
Figure 6 on page 4. Afterward, continue reading
instructions below.
5. Screw oil fill cap/dipstick back into oil filler tube. Tighten
securely.
6. Wipe away any spilled oil.
C. Filling Fuel Tank
An adult should fuel this engine.
NEVER allow children to refuel this
engine. Gasoline (fuel) vapors are highly flammable and
can explode. Fuel vapors can spread and be ignited by a
spark or flame many feet away from engine. To prevent
injury or death from fuel fires, follow these instructions:
1. Stop engine and allow it to cool before refueling.
2. Be sure engine is outdoors and in a well-ventilated
area.
3. Clean area around fuel fill cap and remove fuel fill cap.
NOTE
For recommended fuel, see Table 2 and "III. Oil and Fuel
Specifications" instructions on page 4. Afterward, continue
reading instructions below.
4. Using an approved red GASOLINE container, add fuel
slowly, being careful to avoid spilling. DO NOT overfill
fuel tank. Leave space in the tank to allow fuel to
expand without overflowing.
5. Replace fuel fill cap securely and wipe up spilled fuel
before starting engine. If fuel is spilled DO NOT start
engine. Move machine away from area of spillage.
Avoid creating any source of ignition until fuel vapors
are gone.
WARNING
Figure 7. Engine with Oil Fill Cap/Dipstick
1. Oil Drain Plug
2. Oil Fill Cap/Dipstick
3. Air Intake Screen
4. Grounding Post
5. Spark Plug Cap
6. Spark Plug Wire
1
23
456
The Twin Cylinder Engines have two spark plug
connections.
To Next Page
Loading...
