MADE IN CHINA
After mode 1 takes off, the
aircraft lights are always
flashing and cannot be hovered.
The ground is too smooth, and the environment is
too dark, which will cause the optical flow lens to be
out of position. Please take a place where the light
is good and the ground is not reflective.
Problem
1
Solution
Common Troubleshooting
GPS positioning is not good, the interference is too
big, please get open space, no cover, no wires, etc.
After mode 2 takes off, the
aircraft always flashes and
cannot hover, floating and
floating. The remote control
switches between modes 1
and 2.
The aircraft motor can receive,
it can't fly, and the light flashes
quickly and slowly.
2
Recalibrate the compass
The aircraft is shaking very
badly
The blade is deformed or damaged, and the blade
needs to be replaced.
3
4
4K 5G WIFIcameraremote control
Rear rocker
arm B
camera Silicone pad battery
Geomagnetic
module
GPS module Motherboard Charging Cable
Optional accessories
-23-
To Previous Page
Loading...