Teesa TSA3530 - Page 21

Owner’s manual 21
EN
1. Before using for the rst time, clean all parts of the accessories, rinse and dry.
2. Insert the worm shaft in the cutter housing.
3. Fit the cutter blade on the shaft with the cutting edges outside.
4. Place the selected disc over the blades ensuring the pin ts in the cut-out.
5. Fix the screw ring on the cutter housing.
6. Check the assembly, the shaft should have no play nor be able to turn on itself.
7. Oer up the assembled mincer attachment, titled towards you, to the outlet and engage
it fully. Return the feed tube to a vertical position by turning to the rear until it stops.
8. Place the removable tray on the feed tube.
9. Rotate the speed knob to start mincing. Move it back to 0 to stop operating.
CAUTION: Insert the pieces of meat in the feed tube piece by piece using the pusher. Never
push the meat with a nger or any other kitchen utensil.
DISASSEMBLE
CAUTION: Press the release button and rotate the cutter housing to dissemble the body.
BLENDER
1. Clean the juice glass and the cover of juice glass before mixing food. Then, insert food
into juice glass and put the cover on.
2. Install juice glass to the xed seat securely (rotate and tighten the juice glass as indicated
on the markings at the bottom of the blender jug casing).
• Please note, when the lid of juice glass is open, the device will not start operation.
• When the top lid of the device is opened but juice glass has not been installed, the
device will not start operation either.
• Transparent measuring cup placed in the middle of the juice glass cover can be
removed and will not aect the operation of the device.
3. Rotate the speed knob to start operating. Move it back to 0 to stop operating.
4. Rotate the juice glass in opposite direction after nishing mixing to disassemble the
blender.