8
EN
Z
Cleaning and care of the other parts of the appliance
• Unplug the appliance before cleaning.
• Clean the outside of the Rice Cooker, the inside of the lid
–
Fig.19 and the cord with a damp cloth and wipe dry.
Do not use abrasive products.
• Do not use water to clean the interior of the appliance body
as it could damage the heat sensor.
Technical troubleshooting guide
Malfunction description Causes Solution
Any indicator lamp off and no
heating.
Rice cooker not plugged.
Verify the main plug is well
engaged in the product body.
Any Indicator lamp off and
heating.
Problem of The connection of
the indicator lamp or Indicator
lamp is damaged.
Send to authorized service
center for repair.
Cooking Indicator lamp off,
keep warm indicator on.
Cook button is not in cooking
position.
Put the cook button in low
position (cooking).
Steam leakage during using.
Lid is badly closed.
Open and close again the lid.
Micropressure valve not well
positioned or uncomplete.
Stop the cooking (unplug the
product) and check the valve is
complete (2 parts locked
together) and well positioned.
Lid or micropressure valve
gasket is damaged.
Send to authorized service
center for repair.
Rice half cooked or overtime
cooking.
Too much or not enough water
compared to rice quantity.
Refer to IFU for water quantity.
Automatic warm-keeping fails
(product stay in cooking
position, or no heating).
Send to authorized service
center for repair.
Water leakage on the table.
Dew collector missing or dew
collector overflow.
Empty the dew collector for
each use verify good
positionning of the dew
collector.
Remark: if inner bowl is deformed, do not use it anymore and get a replacement bowl from
the authorized service center for repair.
RICE_COOKER_EASY-COOK_NC00120533_Mise en page 1 09/10/13 09:35 Page9
To Next Page
Loading...
