Before reinstalling the ball, check that the
pipe is not blocked by blowing into it,
from the opposite side to the picture
above.
Press on the internal part of the safety
valve spring, from the opposite side to
the picture shown above, to check that
it is not clogged.
Check that the manometric rod
(above) is not blocked and correctly
positioned. Clean if necessary.
Do not clean any part of the Cook4Me
with abrasive sponges or wire wool.
Clean the upper part of the cooking
bowl using a damp cloth. Clean
the area behind the condensation
collector using a damp cloth. Rinse the
condensation collector and replace.
Clean the outside of the appliance’s
lid using a damp sponge. Clean the
silencing pressure valve at the back
of the lid. Pull out the valve cover
from the lid, then take out the valve
and clean it under running water.
Reassemble the valve and return it to
its original position in the lid.
Clean the seal on the metal plate using
a damp cloth then rinse thoroughly. Do
not use sharp objects.
Note: The seal is non-removeable
from the metal plate.
43
CLEANING AND MAINTENANCECLEANING AND MAINTENANCE
TEFAL-Notice_COOK4ME_EN.indd 42-43TEFAL-Notice_COOK4ME_EN.indd 42-43 10/03/14 12:1210/03/14 12:12
To Next Page
Loading...
