TEFAL HOME CHEF Smart Pro - Troubleshooting (Continued); Error Codes and Specific Issues

24
Problem Possible reasons Solutions
Steam leakage from lid
Sealing gasket is broken.
Send to repair and
maintenance department.
Residue in the sealing gasket.
Clean and remove the
residue.
The sealing gasket was not
properly installed.
Intense release of
pressure from pressure
limit valve
Faulty pressure control
resulted in release of pressure.
Send to repair and
maintenance department.
Pressure limit valve did not
fall into place.
Carefully rotate/press the
pressure limit valve to make
itfall into place.
Continuous pressure
release from float valve
Residue in the float valve.
Clean and remove the
residue.
Float valve is stuck. Clean and remove the residue.
The limit valve releases
pressure discontinuously
during cooking progress.
Make the temperature in the
pot more even.
Normal.
"E0" displayed on digital
screen
Top sensor is in short circuit or
open circuit
Send to repair and
maintenance department.
"E1" displayed on digital
screen
Bottom sensor is in short
circuit or open circuit.
Send to repair and
maintenance department.
no bowl Put on the right bowl.
"E2" displayed on digital
screen.
The lid is not in the position
defined for the selected
cooking mode.
Please refer to the cooking
table to check the right
position of the lid for the
program you have selected.
Lid switch sensor does not
function.
Send to repair and
maintenance department.