15
EN
FRY Mode
• This mode fries food in a large quantity of oil - maximum 2 L (-13).
• Below are the power levels and oil temperatures that correspond to
each program:
P1 P2 P3 P4 P5 P6 P7
1200 W 1200 W 1400 W 1400 W 1600 W 1800 W 2100 W
100 °C 120 °C 140 °C 160 °C 180 °C 200 °C 220 °C
• The timer is available in Fry Mode:
Default time Maximum time
15 min 180 min
CLEANING
ERROR CODES
You must disconnect the power lead, wait until the ceramic glass plate
has cooled, then follow the instructions below to clean the appliance:
1. Ceramic glass plate: if the ceramic glass plate is very dirty, clean
using a damp non-abrasive sponge or for more stubborn stains use an
appropriate cleaning product which is designed for use on ceramic hobs.
2. Cooker body and control panel: Use a damp soft cloth to clean. In case
of any oil stains that are not easily removed, wipe away the stains with
a soft cloth rinsed in warm water and a little washing-up liquid and then
clean using a damp soft cloth.
3. Air entry/air exit surface: remove any dust with a cotton bud.
• Receptacle missing or not the correct type:
If the pot base diameter is less than 10 cm or if the pot material is
unsuitable, the buzzer will sound and the digital display shows “E1”.
Change the cookware.
• Protection of the power source against overheating:
If the power source overheats, the induction cooking appliance cuts
off the incoming power supply and the screen displays “E2”. Allow the
hotplate to cool: if the defect persists, please contact the customer service.
• Over or under- voltage protection:
If the voltage is greater than 265 V - 285 V, the incoming power supply for
To Next Page
Loading...
Need help?
General
