22
The bowl does not drain
-The temperature of the fat is still too high.
-The drain button is not on the open
position .
-The bowl is wrongly positioned.
-The filter grid is blocked or clogged.
-The oil/fat container is set or solidified.
Oil leaks
-The drain valve is not in place.
-The oil/fat container is full.
-The drain valve is wrongly positioned.
-The seal of the drain valve is not in place.
-The container’s fill tube is blocked.
-The fill tube cap is not in place.
Difficult to see through the viewing window.
-Too much cooking without cleaning the win-
dow.
-Clean with a non abrasive cloth.
-Wait for the temperature to go down.
-Place the drain button onto the open posi-
tion .
-Replace the bowl correctly.
-Empty the bowl into a container and clean
the filter grid.
-Warm the fryer for a few minutes (4-5 min.).
-Place the drain valve in the bowl.
-Place the drain button onto the closed posi-
tion, take out the oil container and empty it.
-Empty the bowl into a container. Dismantle
and refit the valve following the instructions
in the directions for use.
-Replace the seal.
-Put the drain button onto the closed posi-
tion, take out the container, empty the fill
tube following the instructions in the direc-
tions for use.
-Replace the fill tube cap (see p. 4).
-Put the lid through the dishwasher or clean it
with a sponge to which you have added
some washing-up liquid.
-Leave the window to dry in the surrounding
air or wipe it with a clean cotton dishcloth
and lemon juice.
HELPLINE
For any problems or queries please telephone:
0845 602 1454 (UK - calls charged at local rate)
(01) 4751947 (Ireland) or consult our website: www.tefal.co.uk
Any repairs must be carried out only by an approved Service Centre using
original spare parts.
2808-ME OLEO-M2 13/01/03 16:43 Page 22
To Next Page
Loading...
Need help?
General
