22
I cannot close the lid:
If your pressure cooker has
been heated without any liquid
in it:
The pressure indicator does not
move up:
The pressure indicator has lifted
up and no steam escapes from
the release outlet during
cooking:
If steam escapes from around
the control module: check:
Steam is leaking around the lid:
check:
If one of the security devices is
activated (safety valve or seal):
Regular beeps and --:-- display
occur on the timer:
■ Make sure the jaws are fully open before fitting
the lid onto the pot.
■ Have it checked at any TEFAL Approved Service
Centre.
■ This is normal during the first few minutes of
heating.
■ If this condition remains unchanged, check that:
The heat is turned up to the highest position.
The quantity of liquid inside the pressure cooker is
sufficient.
The programme selector is not set to .
The cooker is firmly closed.
■ Set the programme selector to :
- If no steam escapes, put your pressure cooker under
cold water to release the steam, then clean the
operating valve and release outlet.
- If steam escapes, the pressure level has not been
reached yet: set the selector back to the initial
position.
■ The control module is sufficiently screwed on.
■ Good condition and correct installation of the seals
on the operating and safety valves.
■ The lid closes correctly.
■ The seal is correctly fitted onto the lid.
■ The seal is clean and not damaged. Replace it if
necessary.
■ Lid, safety valve and operating valve are clean.
■ The edge of the pot is not damaged.
■ Turn off the heat source immediately.
■ Let the pressure cooker cool down.
■ Open the cooker.
■ Check and clean the operating valve, steam
release outlet, safety valve and seal.
■ Check that the timer is correctly fitted onto the
control module.
Frequently Asked Questions
4050-4133255 CLIPSO UK-M5.qxp 14/09/04 14:18 Page 22
To Next Page
Loading...
