TEFAL SILENCE FORCE MULTI-CYCLONIC - Page 7

6
* Model dependent: these parts are specific to certain models or they are accessories that can be purchased separately.
EN
If your vacuum cleaner does not function :
• Check that the appliance is plugged in correctly.
If the suction attachment is dicult to move :
• Reduce the power by opening the mechanical power control on the butt or by moving the electronic power
control switch towards the MIN position.
• Make sure that the position of the nozzle corresponds to the oor being vacuumed :
- for rugs and carpets, use the nozzle in the retracted brush position,
- for parquets and smooth oors, use the nozzle in the advanced position.
If the power cord does not wind up completely :
• The power cord is slow to wind up: pull the cord out again and press on the power cord rewind pedal.
If your vacuum cleaner stops during use :
• The safety mechanism was triggered. Check the tube and hose for blockage. Check if the bag and lters are
saturated. Leave 30 minutes to cool down before switching the vacuum cleaner on again.
Vacuum cleaners with bag
If your vacuum cleaner suction is not working properly or is making a whistling noise :
• There is a partial blockage in an accessory or in the hose: unblock the accessory or hose.
• The bag is full or saturated with ne dust: replace the bag* or empty the textile bag*.
• The lid is not properly closed: check the placement of the bag, of the dust bag holder and of the EPA lter
casket and close the lid.
• The lters are saturated: clean or change the ltration system EPA casket*, washable EPA lter casket*,
microlter casket*. See supplementary instruction manual).
If the change bag warning light is red :
• The bag is saturated: replace the bag or empty the textile bag*.
• If the warning light remains red after the bag has been replaced: the ltration system is saturated (see
supplementary instruction manual)
If the lid does not close :
• Check to see if there is a bag and a dust bag holder in place and make sure they are well positioned.
• Make sure that the EPA lter* casket or the microlter* casket is well positioned.
Bagless vacuum cleaner
If your vacuum cleaner suction is not working properly or is making a whistling noise :
• There is a partial blockage in an accessory or in the hose: unblock the accessory or hose.
• The ltration system is saturated: clean or replace the EPA* lter casket or the black foam lter* or the
microlter*. See supplementary instruction manual.
• The dust compartment is full: empty and wash it.
• The vacuum lid is not positioned correctly: close the lid correctly.
• The dust collector is not properly tted: reposition it correctly.
• The air outlet grill is tted incorrectly: reposition the air outlet grill correctly.
• There is no microlter or ltration foam: replace them in the air outlet grill.
• There is no EPA lter or washable lter: replace them in the vacuum cleaner.
If the lid does not close :
• Check that the EPA lter casket and the separator are correctly repositioned.
• Make sure that the dust box is well positioned in the dust tray housing.
KEEP THIS USER MANUAL AND YOUR GUARANTEE IN A SAFE PLACE
ENVIRONMENT
• In accordance with current regulations, any appliance that is no longer used must be made permanently
inoperable: disconnect and cut the power cord before disposing of the appliance.
Think of the environment!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local waste collection point.