What to do if the anti calc indicator is flashing on my TEFAL Sv6116?
If the anti calc indicator is flashing on your TEFAL Iron, it means that the anti calc cartridge is no longer efficient. Replace the anti scale cartridge with a new one, then press the reset button for a minimum of 3 seconds. Also, the descaling procedure might need to be performed; see section "Descaling your generator" in this manual to perform the descaling procedure.
Why does my TEFAL Sv6116 leave water streaks on linen?
If water streaks appear on the linen when using your TEFAL Iron, it's likely because your ironing board is saturated with water because it is not suitable for use with an appliance. Check that your ironing board is suitable. We recommend that you use a vented/mesh type ironing board.
Why does my TEFAL Iron leave brown streaks on linen?
If brown streaks come through the holes in the soleplate of your TEFAL Iron and stain the linen, it is because you are using chemical descaling agents or additives in the water ironing. Never add this type of product in the water tank (see “for what water may be used”). Contact an Approved Service Centre.
What to do if anti calc indicator is still flashing after replacing the cartridge in my TEFAL Iron?
If the anti calc indicator is still flashing after replacing the cartridge in your TEFAL Iron, it means that you have not pressed the reset button. Press the reset button until the light stops flashing.
Why is my TEFAL Iron producing little or no steam?
There are several reasons why your TEFAL Iron might not be producing steam: * The water tank may be empty - fill the tank. * You may be using steam for the first time, or you have not used it for some time - press the steam control button away from your ironing board until the iron produces steam. * The setting is not correct (1 dot / 2 dots) and the soleplate is not hot enough to produce steam - set the iron at 3 dots (••• or MAX) and wait for the iron thermostat light to go out before activating the steam button again. * Steam cannot be produced at the temperature you have selected - set the thermostat control in the coloured zone (••• or MAX). * There is no anti calc cartridge in the appliance or it is not properly installed - make sure the anticalc cartridge is installed and...
Basic steps to set up and begin using the steam generator.
Instructions on how to properly fill the appliance's water tank for operation.
Guidance on safely securing and transporting the steam generator.
Explanation of temperature and steam settings for optimal ironing of different fabrics.
How to use the steam generator for vertical steaming of hanging garments.
Information on the automatic shut-off safety feature and how to resume operation.
Instructions for removing and emptying the scale collector to maintain performance.
Step-by-step guide for the descaling process to remove mineral buildup.
Procedures for cleaning the appliance's soleplate and exterior plastic parts.
Proper methods for storing the steam generator after use to ensure longevity.
Crucial safety advice for correct appliance use and hazard prevention.
General| Power | 2400 W |
|---|---|
| Soleplate Technology | Durilium Airglide |
| Soleplate Material | Ceramic |
| Vertical Steam | Yes |
| Anti-Drip | Yes |
| Anti-Scale System | Yes |
| Auto Shut-off | Yes |
| Self-cleaning | Yes |
| Anti-calc system | Yes |
| Heat-up Time | 2 minutes |
To Next Page