42 43
5.
IS THERE A PROBLEM WITH YOUR APPLIANCE?
According to model:
• The charger is getting hot:
4 This is perfectly normal. The vacuum cleaner can remain permanently connected to the charger
without any risk.
• The charger is connected but your appliance is not charging:
- The charger is incorrectly attached to the appliance or is faulty.
4 Check that the charger is properly connected or contact an Approved Services Centre to change
the charger.
• Your appliance stops during use:
- Your appliance may be overheating.
4 Stop the appliance and leave cool for at least 1 hour.
4 If it overheats on repeated occasions, contact the Approved Services Centre.
• The appliance stopped after the charge light was ashing:
- The appliance has run out of battery charge.
4 Recharge the vacuum cleaner.
• The power-brush is not working properly or makes a noise:
- The rotating brush or hose are obstructed.
4 Stop the vacuum cleaner and clean them.
- The brush is worn.
4 Contact an Approved Service Centre to change the brush.
- The belt is worn.
4 Contact an Approved Service Centre to change the belt.
• The power-brush stops during vacuuming:
- The safety function has been triggered.
4 Stop the vacuum cleaner. Check that nothing is obstructing the rotation of the brush; if there is an
obstruction, remove it and clean the power-brush, then turn on the vacuum cleaner.
• Your vacuum cleaner is not vacuuming as well, is making noise, whistling:
- The intake channel is partially blocked.
4 Unblock it
- The dust collector is full.
Empty it and clean it.
- The dust collector is not properly tted.
4 Re-position it correctly.
- The intake head is clogged.
4 Remove the power-brush and clean it.
- The protective foam lter is saturated.
4 Clean it.
EN
5.
RG74XX
Serial No. Error Error description
1 Left wheel error
Left wheel is not working, overload in left wheel.
Indicator POWER ashes twice and beeps once.
2 Right wheel error
Right wheel is not working, overload in left wheel.
Indicator POWER ashes 3 times and beeps once.
3 robot lifted error
The robot is lifted over 1 second.
Indicator POWER ashes 4 times and beeps once.
4 Front wheel error
Front wheel is not working, is stucked.
Indicator POWER ashes 5 times and beeps once.
5 Cli sensors error
Cli sensors are not working.
Indicator POWER ashes 6 times and beeps once.
6 Low battery error
POWER is going to be dead.
Indicator POWER ashes 7 times and beeps once.
7 Front bumper error
Switch on the left or right side of bumper is not restored.
Indicator POWER ashes 8 times and beeps once.
8 Middel brush error
Main brush is not working, overload.
Indicator DOCKING ashes 2 times and beeps once.
9 Side brush error
Side brush is not working, overload.
Indicator DOCKING ashes 3 times and beeps once.
10 Wall sensor error
Wall sensor error.
Indicator DOCKING ashes 4 times and beep once.
11 Fan motor error
Fan motor is not working, overload.
Indicator DOCKING ashes 5 times and beeps once.
12 No dustbin error
No dustbin.
Indicator DOCKING ashes 6 times and beeps once.
13 Charging error
Robot is not well connnected to the docking station.
Indicator DOCKING ashes 7 times and beeps once.
Please keep this user manual.
To Next Page
Loading...
