Note：Plug-in and plug-out test is under no-load condition
2.4 Product Function
Leakage Protection（AC 30mA+DC 6mA）
Over temperature protection
3. Instructions and Status Display
Please check points before use
1. Ensure that the product is not scratched, rusted, broken, etc.
2. Make sure there are no objects in the power plug or socket, vehicle plug or socket
3. Do not charge if the surface of the socket or plug is damaged, rusted, cracked, or
connection is too loose.
4. Please Wipe the plug or socket with a dry and clean cloth When it is dirty or wet.
How to start charging
1 Plug the power plug into the power socket firmly.
2 Remove the protective cap of the plug, open the vehicle socket cover, then insert
the charging plug into the socket at the vehicle end. After the plug is in place, press the
start button and start charging.
To Next Page
Loading...