5
1.2 Washing programs
The dishwasher is equipped with a control panel and an
DISPLAY (8), described in chapter “3.Description of the controls”, from
which it is possible to carry out all the power switch-on, switch-off and
programming operations.
Before starting a washing program make sure that:
• The water supply tap is open.
• The correct amount of detergent has been added to the
dispenser.
• The baskets have been correctly loaded.
• The spray arms are able to rotate freely and without
obstruction.
• The dishwasher door is securely closed.
In this dishwasher model all the programming operations are possible
only with closed door. With open door, on the 3-FIGURE DISPLAY (8)
will appear the symbols – and the PILOT LIGHT PROGRAMS (3)
remains out.
Keep pressing the PROGRAM SELECTION button (2) until the indicator
light corresponding (3) to the desired program illuminates.
To annul the current program, press the START/PAUSE button (4) for a
few seconds, until the PROGRAM STARTED light (5) stop flashing. Now
press the START/PAUSE button (4) again until “P0” appears on the
display (about 10 seconds).
To Next Page
