ENG
Index
Page
Description of the appliance 11
Instructions for use 11
Cleaning and maintenance 12
Problem solving 12
Sizes and specifications 12
Accessories supplied 13
Installation 13
Active charcoal filters 13
A Electronic programmer control box
with buttons to control speed, light and
power in use indicators DISPLAY.
B Metal filters.
C Lamps - 20 W (G-4).
D, E Vertically adjustable tubecovers.
Switch on the extractor fan a few minutes before
you start to cook in order to ensure that a steady air
flow has been established before fumes appear.
Allow the extractor fan to run for several minutes
after you have finished cooking (between 3 to 5
minutes) in order to expel all the grease from the
outlet duct. This prevents the return of grease,
smoke and smells.
Proceed as follows:
1) Turn the kitchen hood on and choose the
required speed.
2) Press "timer". The "Program DISPLAY" will
flash.
3) Select the required time by pressing the
increase and decrease speed selectors.
There is a variation of 5 in 5 minutes.
(Min.= 5 min.; Max.= 45 min.).
4) Once the required time has been selected,
press "timer" again to memorise the
program.
5) The kitchen hood will turn itself off once the
programed time has finished.
The intensive speed "H" can only be selected
manually and will change to speed 2 after
approximately 10 minutes.
Clean the filters when the saturation indicator
lights up. (See page 12, Filter cleaning
section).
Once you have cleaned the filters, and with
the hood turned off, press the “Filter
Saturation RESET” button for 3 seconds and
the indicator will switch itself off.
Instructions for use
Description of the appliance
You may control the kitchen hood by operating the
controls as shown in the diagram.
Programming timer
Filter saturation indicators “F”
11
To Next Page
Loading...
