Index
PPaaggee
DDeessccrriippttiioonn ooff tthhee aapppplliiaannccee 1111
IInnssttrruuccttiioonnss ffoorr uussee 1111
CClleeaanniinngg aanndd mmaaiinntteennaannccee 1122
PPrroobblleemm ssoollvviinngg 1122
SSiizzeess aanndd ssppeecciiffiiccaattiioonnss 1122
AAcccceessssoorriieess ssuupppplliieedd 1133
IInnssttaallllaattiioonn 1133
AAccttiivvee cchhaarrccooaall ffiilltteerrss 1133
AA
Electronic programmer control box
with buttons to control speed, light and
power in use indicators DISPLAY.
BB
Metal filters.
CC
Lamps - 20 W (G-4).
DD,, EE
Vertically adjustable tubecovers.
Switch on the extractor fan a few minutes before
you start to cook in order to ensure that a steady air
flow has been established before fumes appear.
Allow the extractor fan to run for several minutes
after you have finished cooking (between 3 to 5
minutes) in order to expel all the grease from the
outlet duct. This prevents the return of grease,
smoke and smells.
Proceed as follows:
1) Turn the kitchen hood on and choose the
required speed.
2) Press "timer". The "Program DISPLAY" will
flash.
3) Select the required time by pressing the
increase and decrease speed selectors.
There is a variation of 5 in 5 minutes.
(Min.= 5 min.; Max.= 45 min.).
4) Once the required time has been selected,
press "timer" again to memorise the
program.
5) The kitchen hood will turn itself off once the
programed time has finished.
The intensive speed "H" can only be selected
manually and will change to speed 2 after
approximately 10 minutes.
Clean the filters when the saturation indicator
lights up. (See page 12, Filter cleaning
section).
Once you have cleaned the filters, and with
the hood turned off, press the “Filter
Saturation RESET” button for 3 seconds and
the indicator will switch itself off.
IInnssttrruuccttiioonnss ffoorr uussee
DDeessccrriippttiioonn ooff tthhee aapppplliiaannccee
You may control the kitchen hood by operating the
controls as shown in the diagram.
Programming timer
Filter saturation indicators “F”
11
ENG
To Next Page
Loading...
