9
User Instructions
Using the Hob
Ignition Button
Press and turn the control knob towards
the large ame position.
Pressing the control knob down will
engage the electronic ignition and allow
the gas to ow.
Manual Ignition of the Gas Burners
In the case of electricity failure resulting
in loss of electronic ignition follow this
procedure.
To ignite one of the burners, press and turn
its knob counter-clockwise so that the knob
is in max. position, ignite with a match,
taper or another manual aid to its upper
circumference. Move the ignition source
away as soon as you see a stable ame.
Flame failure device:
This cooker is equipped with a ame failure
device.
In order for these to work correctly and to
prevent the ame going out when you rst
ignite your burners, keep the knob pressed
and hold for 10 seconds after the burner has
ignited.
Control of the hob burners
The knob has 3 positions: Off
(l), max (big
ame symbol) and min (small ame symbol).
After you ignite the burner in max. position you
can adjust the ame length between max. and
min. positions.
Do not operate the burners when the knob
position is between max. and off positions.
After the ignition, check the ames visually. If
you see yellow tips, lifted or unstable ames;
turn the gas ow off, and check the assembly
of burner caps and crowns. Also, make sure
that no liquid has spilled into the burner caps.
If the burner ames go out accidentally, turn
the burners off, ventilate the kitchen with fresh
air, and do not attempt re-ignition for 90 sec.
Left front burner Left rear burner
Large ame Small ame
Hob Burner Control
To Next Page
Loading...
