USE AND INSTALLATION MANUAL ELFO
23
GENERAL INFORMATION
The Owner’s Manual is an integral part of the
equipment; it is recommended to read and kept with
care.
Unpack only with equipment placed in the installation
position. After removing the packaging, handling
should be carried out by qualified personnel and
equipped with adequate facilities to the weight of the
structure. The manipulation of the condensing unit
is only permitted in the vertical position maintained
equipment.
The operating temperature (outside temperature) for cooling is of 18/43 ° C.
For the heat pump is -7/43 ° C.
To disperse the parts of the package, or leave them
within reach of children as they are potential sources
of danger. Packaging must be disposed according to
local legislation.
Check upon receipt that there are no transport
damage and / or handling, and that in the package
are present all desired accessories.
1.7 BEFORE INSTALLING
Before installing the equipment read carefully and keep the
user manual and general conditions tekno point here below.
1. Make sure that the equipment meets the system
requirements.
2. Check that the refrigerant and water pipes are correct to
manufacturer’s instructions.
3. Make sure that the electrical connection terminals arrivals
the correct voltage (see type plate on the equipment applied
identification). An incorrect voltage compromise irreparably
major equipment components.
4. If you were to turn on alarms, refer to the user manual or
contact the manufacturer of the CAT.
5. Do not force for any reason the operation of the machine
tampering or altering the safety devices on the inside.
6. You can not make starts with incomplete systems,
provisional or performed in a precarious way.
7. The connections to the machine must be performed by
trained and competent personnel and must meet all safety
standards and protection of health at the time and in force in
the country where it operates.
8. The technical documentation (diagrams and operating
instructions) must be kept in good condition in a location
easily accessible for quick reference when needed.
9. The equipment must not be used for purposes that do not
match the specifications for which it was built.
10. Respect the clearances indicated in this manual to ensure
good access to the maintenance of the machine.
11. In the event occurring in damage caused by failure to
observe the above points or the information contained in this
booklet, the manufacturer reserves the right to partially or
totally cancel the warranty.
12. For any clarification, please contact our technical
department.
Temp. Indoor [°C] Temp. Outdoor [°C]
Thermal power Max. 27/- 24/18
Cooling capacity Max. 32/23 43/26
1.6 OPERATING LIMITS
To Next Page
Loading...
