To Next PageTo Next Page
Need help?Do you have a question about the TekTone Tek-CARE400 and is the answer not in the manual?
Explains the nature and cause of static electricity.
Describes the potential damage static discharge can cause to electronic equipment.
Provides measures for installers and users to prevent ESD damage.
Details how to configure the system using master station interfaces.
Guides on how to update the system's software components.
Lists common installation pitfalls and how to prevent them.
Details the NC455CE module, its features, and connections.
Describes the NC356CE module for Tek-CARE300/II systems.
Explains the NC450 Central Equipment cabinet and its modules.
Details the NC450MICRO compact central equipment cabinet.
Describes the PM453 module for IR400-series stations.
Details the PM455 module for P5 stations.
Explains the PM456 module for Tek-CARE300/II systems.
Details the NC415AV and NC404TS master station units.
Describes the NC401VFD and NC402TS master station units.
General overview of P5 series stations and their features.
Describes the IR411P5 and IR412P5 single/dual patient stations.
Describes the IR410P5 staff station for staff communication.
Information on the IR416P5 vandal-resistant psychiatric staff station.
Details the IR415P5 duty station for call annunciation.
Lists various call cords and pillow speakers available.
Details the LI484P5 corridor lights and their features.
General overview of SF300-series peripheral devices.
Information on the SF337C emergency shower switch.
Describes the SF338A staff emergency switch.
Information on the SF341B code call switch.
Describes the SF350B presence station for staff registration.
Details the SF440P5 supervised emergency call switch.
General overview of IR400-series stations and their features.
Describes the IR411P5 and IR412P5 single/dual patient stations.
Details the PM421/PM422 pillow speaker & bed interface modules.
Details the LI482/LI484 corridor lights and their features.
Details the LI484Z addressable standalone zone lights.
General overview of SF400-series peripheral devices.
Describes the SF483 standalone bath emergency station.
Details the SF441 code call switch.
Covers wiring for Tek-CARE network connections.
Details on master station port connections and requirements.
Wiring for NC402TS master stations to the Tek-CARE Network.
Procedures for assigning IP addresses to NC402TS master stations.
Describes patient station port connections on PM453 modules.
Patient station port connections on NC455CE modules.
Configuration settings for central equipment.
How to set DIP switches and addresses for NC455CE.
Instructions for installing backup batteries in CE modules.
DIP switch addresses for IR400/SF480 stations and zone lights.
Station numbering and addressing for P5+ stations.
Station numbering and addressing for Tek-CARE300/II stations.
Steps for configuring pagers using the LS450 Config Tool.
Setting up maintenance fault notifications.
Instructions for replacing the main power fuse.
Procedures for replacing patient station call cords.
How to replace corridor and zone light bulbs.
Expected voltage readings for various system connections.
Interpretation of LED status for various modules.
Common symptoms and suggested solutions for system issues.
Specific troubleshooting for master stations.
Troubleshooting patient station call placement and cord issues.
Expected voltage readings for connections to this module.
Troubleshooting tips specific to this module and connected stations.
General| Category | Conference System |
|---|---|
| Model | Tek-CARE400 |
| Microphone Type | Electret condenser |
| Impedance | ≤2.2kΩ |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Sensitivity | -38dB ±3dB (0dB=1V/Pa at 1kHz) |
