Using the Menus
1740A/1750A Series Waveform/Vector Monitor User Manual
3-16
Preset Menu
The 1740A/1750A--Series has 10 presets capable of storing
front-panel setups. Nine of the presets are user-program-
mable and one is factory pre-programmed. The factory
programmed setup is as follows:
WAVEFORM, CH-A, DC REST
ON
, 2LINE SWEEP, REF internal, and menus off.
Factory-programmed setup:
WAVEFORM DISPLAY, CH-A
INPUT, DC REST ON,
10 µs SWEEP, REF internal, and menus
off.
Push the
PRESET menu button to access the on-screen menu,
illustrated in Figure 3-5. Turn the left bezel control to select
the
PRESET location to be acted on (presets 1-- 9 are available
through the menu). Next, use the bezel button corresponding
to the desired action (
RECALL, STORE, RENAME,orRECOV-
ER
). When a bezel button is pushed, a box flashes momen-
tarily around the on-screen label to verify that the selection
has been made.
VERTPOS
HORIZPOS
CLEAR
MENU
Bezel
Buttons
Left Center Right
PRESET 1
PRESET 2
PRESET 3
PRESET 4
PRESET 5
PRESET 6
PRESET 7
PRESET 8
PRESET 9
FACTORY
RECALL
STORE
RENAME
RECOVER
Figure 3-5. The PRESET menu display.
To Next Page
Loading...
