Need help?Do you have a question about the Tektronix AFG3252 and is the answer not in the manual?
General| Type | Function Generator |
|---|---|
| Model | AFG3252 |
| Brand | Tektronix |
| Channels | 2 |
| Sample Rate | 250 MS/s |
| Vertical Resolution | 14 bits |
| Output Impedance | 50 Ω |
| Modulation Types | AM, FM, PM, FSK, PWM |
| Sweep Modes | Linear, Logarithmic |
| Waveform Types | Sine, Square, Pulse, Ramp, Noise, Arbitrary |
| Interfaces | USB, LAN, GPIB |
| Power Requirements | 100 to 240 VAC |
Explains how to perform self-tests and self-calibration.
Procedure to set high and low voltage limits to protect the DUT.
Steps to update the instrument firmware using USB memory.
Provides a quick overview of the front panel controls and screen interface.
Describes how to select standard and user-defined waveforms.
Explains how to select Continuous, Modulation, Sweep, or Burst modes.
Steps to change frequency and amplitude of the output signal.
Details the connectors and their functions on the rear panel.
Steps to get acquainted with selecting waveforms and adjusting parameters.
Steps to learn how to generate a continuous sine waveform.
Steps to generate a pulse waveform.
Procedure for saving/recalling arbitrary waveforms to/from memory.
Steps to output waveforms stored in memory or USB.
Instructions for editing waveform data using the Edit Menu.
Steps to generate noise or DC signals.
Explains burst modes and how to generate them.
How to set start frequency, stop frequency, and sweep time.
Steps to output an Amplitude Modulation waveform.
Procedure to output a Frequency Shift Keying waveform.
Steps to output a Pulse-Width Modulation waveform.
Steps to set load impedance for accurate output display.
Steps for synchronizing multiple instruments.
Tasks like saving/recalling waveforms, setups, and updating firmware.
Steps to save and recall instrument setups.
To Next Page
