Tektronix AWG5000 Series - Installing the Tekvisa Software

AWG5000 and AWG7000 Series Product Software
6
Installing the TekVISA Software
To install the TekVISA software, do these steps:
1. Before you install TekVISA, close the AWG software.
2. Insert the AWG5000 and AWG7000 Series Product Software CD-ROM into
the CD drive.
3. The AWG software installer should auto run. Click Cancel to discontinue
installing.
4. Double click DPO7 kVisa.exe in the TekVISA folder of the CD-ROM to
install the software.
5. Follow the install wizard instructions.
6. When “InstallShield Wizard Complete” appears, click Finish.
7. The Windows XP operating system restarts. After that, the AWG software
starts automatically.
NOTE. The default path to unzip the TekVISA file is D:\TekVISA. If this
path does not work, change it to C:\TekVISA and then click the Unzip
button.